What the rules depend on
How a textured coating is classified depends on its condition, the area involved and the method used. Small areas in good condition carry less risk, while large or deteriorating coatings, or work using gels or steam, may need extra controls and notification. We assess this before work is planned.
Options besides full removal
Where a full strip-out is not needed or practical, we can talk through other routes:
- Overboarding the coating with plasterboard
- Sealing it in place if it is in good condition
- Removing only the sections affected by building work
- Recording it in an asbestos register so future trades know
Any coating left in place should be documented so no one disturbs it by accident.
How we do the work
Survey and test
We confirm the coating contains asbestos and record where it is and what condition it is in.
Assess and plan
A risk assessment and plan of work are prepared. Larger or poorer-condition areas get stricter controls.
Enclose the area
Work zones are sealed with sheeting, and negative pressure enclosures are built where needed.
Remove with low-disturbance methods
We use wetting, careful scraping and, where suitable, removal of backing boards in whole panels.
Decontaminate and dispose
Waste is bagged in asbestos sacks, the area is cleaned, and a registered carrier removes the waste.
Asbestos waste is double-bagged, sealed and taken by a registered carrier to an authorised disposal site. You receive a waste consignment note as your legal record.